Rubber Components for Agricultural Machinery, Manufactured in India

EPDM is the usual choice for weather-exposed components, for its UV and ozone resistance across −40 °C to +140 °C. Natural rubber blends are used where abrasion resistance matters more than weathering, at −20 °C to +90 °C. Ozone resistance is tested in-house before release.

Compound selection is driven by the specific chemistry in contact. Send the chemical, concentration and service temperature and we will recommend a compound. Send the concentrate as well as the diluted spray — a compound that holds against a field dilution may not hold in the mixing tank.

We supply in bulk. The minimum run is 10,000 pieces per part number, per compound, or quoted against the part where geometry or tooling makes that unrealistic. Prototype and first-article lots sit outside the minimum. Lead time is confirmed with the quotation, from approved drawing and approved sample.

Yes. Bellows and boots are quoted against convolution count, free and compressed length, diameter, flex-cycle target and service temperature. We hold the geometry and the compound; the cycle life is proved by your rig or a third-party laboratory, and we will support that test.

Yes. Send the physical sample or the equipment make and model and we will produce a drawing and confirm compound selection. A worn part measures smaller than it was made — we dimension to the original intent, not to the wear, and confirm the result with you before tooling.

We hold ISO 9001:2015 — certificate 09111526A, issued by Integral Certification Ltd, valid to 21 February 2027. An IATF 16949:2016 upgrade is in progress, targeted for completion by the end of 2026. ISO 14001 and ISO 45001 are targeted for 2027. Documentation is available on request.